Cults3D
Tool
Zum Modell
Sewing thread spool holder
663
Downloads
33
Likes
0
Makes
Thread spool holder made with BQ PLA Easy Go filament 1.75mm. Layer height 0.2mm. Wall thickness 1.2mm. Filling 35%. Printing speed 30mm/s. Temperature for the filament 207Cº, plate 50Cº. With skirt or skirt (4 lines). Without supports.
I use it with the yarn cords I bought at Lidl.
At first I thought about using a bearing (wheelman or roller bearing) to make it turn better, but when I tried this model I realized that it was not necessary. In fact, it spins too well. I put a piece of cardboard between the sewing machine and the roll holder with the intention of creating some friction and thus slow down the roll inertia of the roll.
** 1-01-2021 ** I've added three more new options. One with 6mm hole, one with 6.5mm hole and one with 7mm hole.
When printing I get good results if I do the filling first and then the walls. This way, I don't need supports for the curve of the top of the piece.
I use it with the yarn cords I bought at Lidl.
At first I thought about using a bearing (wheelman or roller bearing) to make it turn better, but when I tried this model I realized that it was not necessary. In fact, it spins too well. I put a piece of cardboard between the sewing machine and the roll holder with the intention of creating some friction and thus slow down the roll inertia of the roll.
** 1-01-2021 ** I've added three more new options. One with 6mm hole, one with 6.5mm hole and one with 7mm hole.
When printing I get good results if I do the filling first and then the walls. This way, I don't need supports for the curve of the top of the piece.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
