Jump Rope Prosthetic

This is designed to use the cuff from the Unlimbited arm. I attached the one I used but it was for a small girl and likely you'll want to go and put in your own measurements for that piece. (which also needs to be put in boiling water and reshaped seeing as it's printed flat for strength.) I used 2 screws, an m4 bolt, 2 washers and a wing nut. I put the 2 screws between the unlimbited cuff and the base to ensure it held. I put a bolt and 2 washers and a wing nut to make adjustable tension for the hinge. The only supports needed are in the middle of the cap (I made sure to only put them in the middle to not mess up my threading) Rope can be slid down the slit in the side of the handle holder which should make it so it can be used with multiple jump ropes. I would recommend customizing your own cuff to attach (this was made for a little girl.) Some velcro required for the cuff.