Jumper T-Lite re-shell

This is a case for the guts of a Jumper T-Lite radio. It makes the radio compatible with a 3.5" screen [a 3.5" screen](https://www.amazon.com/dp/B08JPF6WHZ?ref=ppx_yo2_dt_b_product_details&th=1), which in tern makes the radio more packable by protecting the sticks. It also makes it slightly more comfortable (in my opinion) for pinch-gripping, and makes the battery replaceable.

For this build, you will need:
4x M3x15 cap-head screws
2x M3x10 cap-head screws
1x M3x50 cap-head screw
2x M3x10 flat-head screws
9x M3-size thermo-set inserts
a soldering iron
some wire
A single-slot 18650 holder

Recommended extras:
An IN5822 or similar diode to add reverse-polarity protection to the battery (prevents charging through the USB-C port)
A IRL540N MOSFET and 10MΩ resistor to deliver FULL, UNBRIDLED POWER to the module bay.

It's necessary to extend the wires on the gimbals a bit to acommodate the wider spacing. Other wire leads may also need to be lengthened.