Thingiverse
Junction Box PG16
von Bjorn_
0
Downloads
2
Likes
0
Makes
This is a simple junction box with 3 holes for PG16 cable glands. (PG glands are slowly phased out but are still found everywhere.)
The lid snaps on the box and has a little edge preventing any dust from entering. Note that there is no room for a seal so it's not waterproof.
Printed in PETG without any support.
The lid snaps on the box and has a little edge preventing any dust from entering. Note that there is no room for a seal so it's not waterproof.
Printed in PETG without any support.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
