Thingiverse
Jupiter lamp mounting adapter
von link0007
21
Downloads
9
Likes
0
Makes
Bracket to connect the Jupiter lamp (https://www.thingiverse.com/thing:2747956) to an Ikea lamp base (in my case an INGARED lamp, but I'm fairly sure any small-fitting lamp would work)
It is designed to be screwed down with the typical screw thingy that comes with the lamp, and then you can add the bulb and click in the Jupiter. Snaps right into place.
Note: because of potentially high temperatures, preferably print in ABS/PETG instead of PLA.
It uses only about 50cm of filament, so no need to swap rolls; just cut off a short piece of filament ;)
It is designed to be screwed down with the typical screw thingy that comes with the lamp, and then you can add the bulb and click in the Jupiter. Snaps right into place.
Note: because of potentially high temperatures, preferably print in ABS/PETG instead of PLA.
It uses only about 50cm of filament, so no need to swap rolls; just cut off a short piece of filament ;)
link0007 veröffentlicht auch auf
10 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
