"Jurassic Lights" | LED Display

*FAIR WARNING: The faceplate WILL fit but its tight because of the teeth, it's like trying to squeeze into your favorite jeans after the holidays—it will fit, but you might need a little wiggle and a nudge!" Light Installation Put aluminum (shiny side up) at the bottom of the baseplate, adhere with glue. (Skip if you don't plan on using a grommet for the wire hole) Get a 16mm Closed Grommet, cut a thin line down the middle, but don't cut it entirely in half. Insert led strip, install along the walls of the print, cut to size. (Personal preference to ensure longevity of adhesive) Hot glue along the lines of the led strip, grommet hole Insert faceplate. Sip on a nice cold beer and admire your handiwork. **I highly recommend turning retraction settings on if you haven't already. Its a vital setting to have on with these light displays. It helps eliminate the chances of blobs or stringing. The other settings are preset but i don't believe retraction settings save over. In any case, these a