Thingiverse
Just a simple calibration block
von confusedCoyote
1
Downloads
0
Likes
0
Makes
Just a simple test block to check the calibration of your printer.
The block increases in height by 10mm and by width by the same amount with a 5mm height (these figures exclude the height of the text)
As always I've included the Sketchup file
The block increases in height by 10mm and by width by the same amount with a 5mm height (these figures exclude the height of the text)
As always I've included the Sketchup file
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
