Thingiverse
Just a sword
von Davidyang7111
198
Downloads
490
Likes
0
Makes
1.This sword just a model, don't hit anything with it.
2.The Blade used 5mm sticks as skeleton and connect all blade parts, also requires super glue.
3.The pommel used 3mm screws to combined with handle.You can put any decorative objects on pommel inside.
4.I suggest the part of blade near guard one that infill set to 100% and closer to the tip is getting lower when you slice each blade.
Because if infill rate all set the same, the blade maybe bending when you hold it and parallel to the ground.
2.The Blade used 5mm sticks as skeleton and connect all blade parts, also requires super glue.
3.The pommel used 3mm screws to combined with handle.You can put any decorative objects on pommel inside.
4.I suggest the part of blade near guard one that infill set to 100% and closer to the tip is getting lower when you slice each blade.
Because if infill rate all set the same, the blade maybe bending when you hold it and parallel to the ground.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
