MakerWorld
Hueforge & Lithophane
Zum Modell
Just Mars HueForge
15
Downloads
8
Likes
6
Makes
Source generated image.Then used HueForge v0.8.0 to create the model.Size 200x200mm. Do NOT adjust the thickness (Z) in your slicer! The layers will not come out right. You CAN adjust the other dimensions (X,Y) though to make it bigger or smaller, just not the thickness.Nozzle: 0.4You may print at higher layer heights below the Min Depth of 0.56mm. The Max Depth is 2.2mm and the Actual Depth is 2.2mmThese were my settings and colors for my print that you see in the picture. Your results may be depending on the filament you use.Filaments Used:PLA Elegoo+ Black Transmission Distance: 0.3 PLA Sunlu META Grey Transmission Distance: 3 PLA Elegoo + Red Transmission Distance: 3.7 PLA Elegoo + Orange Transmission Distance: 4 PLA Elegoo + Yellow Transmission Distance: 4 PLA Elegoo + White Transmission Distance: 8.9 Swap Instructions:Start with BlackAt layer #7 (0.64mm) swap to Navy BlueAt layer #15 (1.28mm) swap to BlueAt layer #17 (1.44mm) swap to GrayAt layer #20 (1.68mm) swap to White for th
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!