Thingiverse
K Cup Holder
von Changc22
312
Downloads
272
Likes
1
Makes
Hello!
This is a simple drop style coffee pod dispenser (keurig cups in my case). Load it from above and they'll stack up. Remove one from the bottom for consumption!
It can be fairly large depending on your needs. I split it up into 2 main parts the bottom dispensing component and the holding cylinders. The dispensing section is about 1 K cup tall, the cylinders are designed to be 15cm tall but nothing will stop you from adjusting the Z scale to fit your needs. I simply hot-glued the sections together and stacked the cylinders.
It's basically a hollow cylinder with a cut out at the bottom. There is also a cut slit going down the front so you can see how many pods are left.
I've loaded it up and it will stand on it's own, but I've design it with a flat portion so it can be attached to a wall (with sticky tack?) or magnetically attached to something (in my case a dish washer).
Enjoy!
This is a simple drop style coffee pod dispenser (keurig cups in my case). Load it from above and they'll stack up. Remove one from the bottom for consumption!
It can be fairly large depending on your needs. I split it up into 2 main parts the bottom dispensing component and the holding cylinders. The dispensing section is about 1 K cup tall, the cylinders are designed to be 15cm tall but nothing will stop you from adjusting the Z scale to fit your needs. I simply hot-glued the sections together and stacked the cylinders.
It's basically a hollow cylinder with a cut out at the bottom. There is also a cut slit going down the front so you can see how many pods are left.
I've loaded it up and it will stand on it's own, but I've design it with a flat portion so it can be attached to a wall (with sticky tack?) or magnetically attached to something (in my case a dish washer).
Enjoy!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
