K1-Max Spool Side Mount

***Added K1-Max Side (spool Scale) Mount.stl with mounting points for spool rotated 90 degrees and 9.128mm vertical hole for pneumatic fitting. after a request from Robgw.***

K1 Max side spool mount that uses the existing rear spool holder that you just screw into the new mount (I used the spool holder from my old S1 pro as it had bearings)

I added a little support under the 2 parts used to screw in the spool holder (see pic) works without support on my printer but to be safe and to make sure fit is tight I used support (It is very tight when you first screw on holder)

you'll also need longer screws, flathead / Allen bolts. 2 M3x10, to attach to frame and 1x M3x18 where it mounts to back of side fan. I used M3x12 and M3x20 as Its what I had.
The top screw for the frame is a little close to the belt on the inside for me so be careful not to use too long a screw on the top.

I used tube clips from the back to secure tube (see pic)

Added optional spacer to fill gap when s