K1C Slim Flattop Riser for CFS (K1C-SFR-CFS)

Design ConceptI wanted to have a clean, flat base on top of the K1C so the CFS can be top-loaded securely like with the Creality K2 + CFS combo, or other brands, where the printer itself has a flat base to rest a multifilament system on top of it. While there are several options, I wanted to create a base that was as low profile as possible so it doesn't add too much height and make the CFS harder to reach and load. I also wanted to still allow some visibility through the base so wanted to incorporate some cutouts. Finally, I wanted to reuse the original transparent lid so it does not go to waste.The design is based on the K1C Slim Lid for CFS, but it has been reworked to enshroud the original lid and only increase the internal height by 6mm to give just enough clearance for the extruder assembly to spare the lid from scrapes. This means less clearance for the PTFE bowden tube versus other risers, but I have found there is enough headroom to avoid feed issues. There is no more allowance for vents in this design, but I have incorporated windows. This remix also loses the flip-open hinge mechanism of the design this remixes, but utilizes the strength of the original transparent lid to support the weight of a fully loaded CFS.For easier assembly, I added snap-fit tabs to connect the pieces together. For these tabs and some large gaps incorporated in the design, I found supports were needed for some of the tabs, but to avoid auto generated supports, I have added the supports into the design. This does mean assembly requires some cleanup, but not as much if you had Creality Print generate tree supports.Print SettingsYou will need to print in these quantities:3x K1C-Flattop-Generic-Corner1x K1C-Flattop-Back-Corner3x K1C-Flattop-Long-Insert1x K1C-Flattop-Short-Insert2x K1C-Flattop-Lid-Left-Corner-CFS*** (OR K1C-Flattop-Lid-Left-Corner-Tabbed-CFS)2x K1C-Flattop-Lid-Right-Corner-CFS*** (OR K1C-Flattop-Lid-Left-Corner-Tabbed-CFS)Print all the pieces upright. You can ignore th