Thingiverse
K1C tool holder
von girthter
5
Downloads
16
Likes
0
Makes
This is a tool holder for the Creality K1C 3D printer. No supports required. Two M3x10 screws are needed to attach it to the printer.
It's made to be attached to the right up corner of the printer as shown on the photos.
Every hole is sloppy to accommodate almost any tools you might have except the spatula spot which is smaller than the one that came with the printer
It's made to be attached to the right up corner of the printer as shown on the photos.
Every hole is sloppy to accommodate almost any tools you might have except the spatula spot which is smaller than the one that came with the printer
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
