K2 Plus air recirculator

Simple air recirculator to keep your hot air in, paired with printed hepa+carbon filters to provide good VOC filtration and minimize leakage. Held in place with 16 1/4in cylinder magnets. Press fit holds well for me, but if yours don't stay in, a drop of glue will hold fine.Intended for use with an internal chute modIncluded 3mf file contains altered print start gcode intended for use with a cartographer+k2improvements, removed purge line and replaced with skirt. End gcode modified to slowly ramp down bed temp from 110 after print finish to minimize warp, with a couple nozzle wipes after first few layers to ensure clean printing. If using stock printer, reset the preset to the settings you default to.Printed with ASA to handle the heat, PLA or PETG will warp and deform over time