Slicer Discord
K2 Plus – CFS Riser, Ventilation, and Storage – 3D-printbaar model van MakerWorld MakerWorld
3D Printer Accessories

K2 Plus – CFS Riser, Ventilation, and Storage

588 Downloads
154 Likes
13 Makes
Model downloaden
Update 2025.02.06 Some people have reported that when they printed, the tolerances were too tight for their printer to handle. The original, now called “Tight”, version has tolerances of 0.14 mm. There is now also a “looser” version that has tolerances of 0.21 mm. This applies only to the seam down the middle front-to-back, as it was reported the other seams were fine. There is a test print for each of these, and I highly recommend printing it to make sure your printer and desired material will work. End of Update In V1, there was a minor design flaw in Parts 3 and 4. There is a part on the bottom of the CFS that juts down that I did not account for. If you already printed parts 3 and 4, you can print 2 of the feet risers and drop them into the back two slots. You will never know the difference. I started from benlevi's BLV - AMS Riser concept and completely rebuilt it for the K2 Plus. Credit to them for the original concept, but this is a new creation. This is a big print, and has bee
Categorie
3D Printer Accessories
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Waarom?
2 kleuren
Eendelig 2 kleuren / AMS
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
Carbon Fiber
Kleuren
2 (AMS/MMU aanbevolen)
Software
Cura, PrusaSlicer of vergelijkbaar
Zelfde ontwerper, meer platforms

Stranula publiceert ook op

40 extra modellen op 1 andere platforms

Geverifieerd door overeenkomende modeltitels op platforms.
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie