K2 Plus Modular Waste Shute

The other poop shutes seem to use a lot of filament and take a ton of time to print. This model is only 0.8 mm thick in most places as we don’t need 5mm of thickness and a bunch of infill to accomplish what basically amounts to plumbing. I’ve printed and tested this entire kit in a couple of hours including the pipes - which are round for a reason (no corners to slow down in and better airflow for the rear fans)

This is a customizable waste shute for the K2 series of printers. Fittings are slip fit and should stay in place given the printer isn’t jostled around. If you opt to use the included clamps or clamp couplers, the magnet dimensions are for 10x2mm magnets.

Most of these models can be printed without supports with the exception of the 90 degree elbow. For that, just pop up some tree supports. I used HyperPLA with 500-600mms wall speeds and this turned out well. I recommend a raft as these have a miniscule surface area on the bottom. As my K2 is on an Ikea Lack table, I just r