Thingiverse
K240-3U
von AllanNorgaard
33
Downloads
23
Likes
1
Makes
Third revision of my 240 K-shaped unibody quad.
Created with the area limitations of an Ultimaker 2 in mind, such that only 1.5mm raft/brim is possible.
A limited amount of support is required, but I doubt it will print nicely without
Assembly:
8x M3x25 + nuts for the body
4x M3x8+ + nuts for camera & video tx
Setup:
*Motor:* Scorpion M-2205
*ESC:* 30A Littlebee
*FC:* Naze32 Acro Rev 6
*PDB:* Matek Micro
*RX:* Turnigy 9X 8ch receiver
And some cheap Quanum FPV kit
I'm not in love with the RX and FC, since they take up way too much space. The hole in the top part is there only to fit their connectors. Once I change these, space should not be an issue, but everything CAN fit inside as it is already.
Created with the area limitations of an Ultimaker 2 in mind, such that only 1.5mm raft/brim is possible.
A limited amount of support is required, but I doubt it will print nicely without
Assembly:
8x M3x25 + nuts for the body
4x M3x8+ + nuts for camera & video tx
Setup:
*Motor:* Scorpion M-2205
*ESC:* 30A Littlebee
*FC:* Naze32 Acro Rev 6
*PDB:* Matek Micro
*RX:* Turnigy 9X 8ch receiver
And some cheap Quanum FPV kit
I'm not in love with the RX and FC, since they take up way too much space. The hole in the top part is there only to fit their connectors. Once I change these, space should not be an issue, but everything CAN fit inside as it is already.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
