Thingiverse
k40 laser door stop
by raptor_demon
143
Downloads
63
Likes
0
Makes
this is a door stop designed for the k40 to help with camera alignment with lightburn.
the door was going too far back. the back holes are 6.2 mm to allow 6 mm magnets to be glued in.
print flat on the long side without supports
the door was going too far back. the back holes are 6.2 mm to allow 6 mm magnets to be glued in.
print flat on the long side without supports
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
