Thingiverse
K8200 adapter
door Dirk_FG
1
Downloads
0
Likes
0
Makes
This adapter exists of two pieces, shell lid and dovetail lid mount. The original SAWoosh shell is used. This remix fits the standard K8200 extruder mount, alongside a fanned V5 hot end. Distance to the hot end fan is about 5mm. The lid piece has openings for guiding the wiring.
The dovetail piece is screwed on first using the two existing hex socket screws, dovetail facing the rear. Then the combined lid piece and shell with probe is slid on to the dovetail piece.
Fits the cheap 3DTouch.
Print settings: PLA+, 215/50 C, 50mm/sec, 0,2mm layer, 40% infill concentric/cubical/concentric. Dovetail has a tight sliding fit.
Good luck!
The dovetail piece is screwed on first using the two existing hex socket screws, dovetail facing the rear. Then the combined lid piece and shell with probe is slid on to the dovetail piece.
Fits the cheap 3DTouch.
Print settings: PLA+, 215/50 C, 50mm/sec, 0,2mm layer, 40% infill concentric/cubical/concentric. Dovetail has a tight sliding fit.
Good luck!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!