K8200 enclosure idea

Here are all my improvements i´ve done on my K8200 Printer.
i would like to share with you.

All improvements costs are lower than 100 €

Enclosure ist made out of 3 IKEA Lack tables 5,99€ each.
The k8200 or 3drag will fit perfectly in it. The enclosure is updatet with some IKEA Led strips to light the printer up.

The electrical box is made out of an Electrical Box 200 x 150 x110
2x 90 mm fan´s and some switches / emergency switch.
i had the problem that the printer disconnects sometimes or the printer stops currently.
Since i had the extra cooling and the box . This problem never appeared again.
One fan blows air into the case, the other one blows the "hot" air out.

Inside the electrical box i used crimp contacts to connect the original k8200 cables to H07 0,75mm2 cable. This one has lower resistance and looks better. And it increases the resistance against mechanical burden.

The Solid state Relais DC DC 8€ each i use for the heater cartridge (work in progress ) and