kali's teeth

--If you choose to print this and get your dangley bits stuck in it its your fault not mine--

~~I may edit the connector to take the notches out of it and maybe reinforce it, though I might not.~~ edited just needs reprinted to confirm correct hole spacing

I'm not the largest tool in the shed but even when the tool is soft its a tight fit.

I suggest removing the points on the teeth unless you want the more intense experience (they still do the job without the very tip)

Should fit all CB-#000(s) devices.

If you have any ideas for modifications feel free to suggest them.

Print settings I used were (not my suggested settings)
.2 layer
3 walls at.8
5 top/bottom at.6
0 infill (don't do this if you plan to use it)
printed with brim

used YuriZaprov's "CB6000 Base #2 Replacement" for the connection point

July 5th update
teeth_v2 is not tested will reprint to test fit when i get more filament.