MakerWorld
Other House Models
Ver Modelo
Kallax shelf support
459
Descargas
364
Likes
201
Makes
Two supports carry a board with a thickness of 18mm. A Kallax compartment can thus be divided evenly into three compartments. The width of the board must be approximately 33.1 mm. However, it is better if the board is slightly wider.
giessener también publica en
2 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!