Thingiverse
KangerTech Subox Mini Grip Case Sleeve
door leeph
6
Downloads
1
Likes
1
Makes
A sleeve / case / grip I designed for the KangerTech Subox Mini. Possibly not for the very latest version, I only have the one that is a couple of years old as of 2017.
Should print with no supports required, 0.2mm layer height, 2 shells/perimeters. If you can set the layer start point to the middle/rear of the case, I designed in a nice ridge that will hide the seam and make the rest of the body nice and smooth.
Interference fit with the Subox Mini but can be removed easily when it's time to change batteries. I assume few people use the charging port so I've not made a cut-out for this.
Rev 1 - Original
Rev 2 - Removed 50% of the Kangertech logo slats as it made the logo too prone to getting messed up during prints since these are effectively small bridging regions. Looks more like the logo on the actual Subox Mini with fewer slats anyhow.
Rev 3 - Redesigned logo cut-out completely to make case easier to print - an unobstructed cut-out with optimised bridging region makes f
Should print with no supports required, 0.2mm layer height, 2 shells/perimeters. If you can set the layer start point to the middle/rear of the case, I designed in a nice ridge that will hide the seam and make the rest of the body nice and smooth.
Interference fit with the Subox Mini but can be removed easily when it's time to change batteries. I assume few people use the charging port so I've not made a cut-out for this.
Rev 1 - Original
Rev 2 - Removed 50% of the Kangertech logo slats as it made the logo too prone to getting messed up during prints since these are effectively small bridging regions. Looks more like the logo on the actual Subox Mini with fewer slats anyhow.
Rev 3 - Redesigned logo cut-out completely to make case easier to print - an unobstructed cut-out with optimised bridging region makes f
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!