Kavetto Modular Tool Keeper

The Kavetto tool holder system uses a set of hard points (Kavetto_Mounts) that can be attached to the chassis of the Replicator 2 and 2X, and other printers that use the same construction, though the set has only been tested on Replicators.

Note: Installation requires the purchase of M5x14 bolts to replace the stock bolts, and are available from McMaster Here: http://www.mcmaster.com/#95263A360

Once the mounts are installed, the tool keepers can be attached in any configuration that is desired. The latches that are printed with the Mounts file are press fit around the bolt hole, and are coded R and L for Right and Left when facing the mount. The R and L markings should be on the inside, and not viewable after installation to ensure proper function. The latches can be rotated down, where they will snap into place and prevent the attachments from disengaging accidentally.

The attachments include the following.

• The Fan accepts most small files, markers, clam knives, Dremel®