KBWhoop

**This quad is beyond fun**. If you are tired of your sluggish E010/H36, or simply want a fun indoor FPV quadcopter, print our frame, install the electronics and get flying!

Note: The quad shown in the pictures is using the motors and props from our initial E010. The motors work just fine, although they could be a little faster for more lift.

Shopping list:
1 x KBWhoop frame
4 x 6x15mm Faster or insane coreless motors (http://a.co/fZoF6bU, http://a.co/1i9wDZ6)
4 x 31mm propellers, 2xCW & 2xCCW (http://a.co/iFZmUP9)
1 x Tiny F3 Evo flight controller (http://bit.ly/2F5UK71)
1 x FSI6-RX Receiver (http://bit.ly/2rARdvy, http://a.co/5Xh91Nj)
1 x Micro AIO FPV camera/tx (http://a.co/5SlxA3y)
1 x JST male battery jack (or whatever battery connector you like)
1 x Rubber hair band (to hold the battery on)

Any 6+ ch. FlySky radio and 5.8GHz FPV goggles should work. I fly with an FS-I6 (http://a.co/7CXQrL8) and a pair of Vision+ goggles from HK (http://bit.ly/2n9E7jw).

Directi