Thingiverse
KEdge Wahoo Adapter
door dothebart
8
Downloads
4
Likes
0
Makes
K-Edge Wahoo holder
===================
The KEdge is a Holder made from alloy. However, its Sigma version is better available and cheaper - so this Thing turns a Sigma version into a Wahoo version by replacing the holder.
Red and thin things are the original parts.
This thing consists of 3 parts:
- Base ring - this gives the snap layer a place to wipe out to when the Wahoo is twisted in
- Snap layer - this has a spring that snaps into the nodges of the wahoo base
- Twist in layer - this has a through whole for the socket, twist it until it snaps in.
To replace the original you need a tiny torx screwdriver. The Base and Snap layer are just stuck on these tiny screws, the screws will have to be gently forced into the Twist in layer.
===================
The KEdge is a Holder made from alloy. However, its Sigma version is better available and cheaper - so this Thing turns a Sigma version into a Wahoo version by replacing the holder.
Red and thin things are the original parts.
This thing consists of 3 parts:
- Base ring - this gives the snap layer a place to wipe out to when the Wahoo is twisted in
- Snap layer - this has a spring that snaps into the nodges of the wahoo base
- Twist in layer - this has a through whole for the socket, twist it until it snaps in.
To replace the original you need a tiny torx screwdriver. The Base and Snap layer are just stuck on these tiny screws, the screws will have to be gently forced into the Twist in layer.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
