Keep Door Open (Door Stop) Cat Entry
von cobra_moses
36
Downloads
32
Likes
0
Makes
I needed to ensure that this particular door stayed open enough to fit my cat as this is the room we keep his litter box (and my kids always want to close this door for some reason).
Keeping it almost closed helps with odors as well. This little door stop sits on top of your door and makes contact with the door jamb. Its 2mm high so there has to be at least that much clearance from the top of your door to the jamb itself. Its designed to sit about 6 inches from the end of the door. Three design with no support, mid-range, to max support are included depending how quick you want your print or how much filament you want to use :)
Go for it!
Keeping it almost closed helps with odors as well. This little door stop sits on top of your door and makes contact with the door jamb. Its 2mm high so there has to be at least that much clearance from the top of your door to the jamb itself. Its designed to sit about 6 inches from the end of the door. Three design with no support, mid-range, to max support are included depending how quick you want your print or how much filament you want to use :)
Go for it!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
