keezer line brackets

Quick modeled and printed these for a keezer build I'm about to complete. I printed one full size and it was too big. 90% is just about a perfect fit for my air lines and collar, the beer lines are a little small but not so small that they crossover to the next slot. I could re-model them if someone was super interested in them being perfect, but for my use it's more than sufficient.

1/4" lag bolts will hold these to the wooden collar, over a layer of reflectix for some extra insulation. Three lines run together from the faucets to a 6 on the sidewall. One gas and one liquid separate for the first keg, then you pop in a 4 for the next keg and a 2 for the keg after that. Should make it easier to manage and keep track of the hoses and disconnects when swapping kegs in and out.

I'll upload a "Made" one after I get it all assembled.