Thingiverse
Kegerator brackets, mounts and hinges
por JLM86
5
Descargas
3
Likes
0
Makes
These are the files for the brackets, mounts and hinges I used on my kegerator.
Stand-off gas inlet and thread block passthrough both use standard PET bottle thread patterns.
Use supports as suggested by your slicer.
Certain parts printed at .16mm layer height for aesthetics but most at .20mm
Infill between 25-35% for most, with lots of walls (6-8). Hinges 50% infill.
Stand-off gas inlet and thread block passthrough both use standard PET bottle thread patterns.
Use supports as suggested by your slicer.
Certain parts printed at .16mm layer height for aesthetics but most at .20mm
Infill between 25-35% for most, with lots of walls (6-8). Hinges 50% infill.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
