Slicer Discord
Kemper Player Plus Two Additional Switches – 3D-Druckmodell von MakerWorld MakerWorld
Electronics

Kemper Player Plus Two Additional Switches

25 Downloads
9 Likes
9 Makes
Zum Modell
You can add two additional switches to the Kemper Player via this print. You need a couple of items; these are the ones I used. 1x 6.35mm Jack to Jack Right Angle AUX Cable - https://www.ebay.co.uk/itm/145224255597 2x Low profile Off-(On) Momentary Prewired Foot Switch - https://www.ebay.co.uk/itm/256206446930 … and also some basic soldering skills. Insert the switches from the bottom. Then cut the cable down to a suitable length and connect the earth wire to both earth wires before soldering the other two wires to the positive wire on each switch. My print was printed in matte grey and stippled with black acrylic paint as I didn't have black filament.
Kategorie
Electronics
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Bemalen
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen