KENWORTH LOGO STEERING MIDDLE

(FIRST MADE PRINT)

Thought I would make a 3D print of a kenworth logo for steering wheel to hide the hole behind it as i use a spacer because of the turn signal and wiper levers behind, i think its a little bit off (not round) not perfect but itll do for me (for now)

i used sticky tack to stick it to the wheel and i also used a 3D pen to join the middle circle to the outer part but you could probably just stick it on to the wheel as well with sticky tack

(MY SETTINGS MIGHT NOT BE RIGHT AS IM NEW TO 3D PRINTING BUT IT TURNED OUT FINE FOR ME AND I USE A MAGNETIC SHEET ON MY HEAT BED FOUND TAPE TO BE TO MUCH OF AN HASSLE STICKING TO PRINTS)

comments and tips/recommended settings/temps welcome

PLA used Formfutura 1.75mm HDglass (RED) and AMZ3D 1.75mm White

IN CURA SPLIT OBJECT INTO PARTS AND DELETE THE 4 BITS AND KEEP THE ROUND PARTS (I USED 14.07)

settings i used on anet a8

for background i used Formfutura 1.75mm HDglass (RED)

layer hight 0.2mm

shell thicknes