Thingiverse
Keurig K-Cafe Riser
por 5dot5six
6
Descargas
8
Likes
0
Makes
This is a riser for the Keurig K-Cafe to prevent splashing. It sounds like Keurig may have different designs. Recommend printing a small piece to test fit interfaces before printing the entire part.
******UPDATE******
Addressing some questions from a fan:
What height coffee cup will fit with this riser? Great question! - A 4.25" (108mm) tall cup should fit just fine.
Are the tolerances of this model exceedingly tight? Another great question! - Since tolerances are typically called out on a 2D print and are not part of the 3D model I can't really say. Any variability would be determined by the accuracy of your 3D printer.
Couldn't you have mimicked the original design? Dynamite! - I could have done a lot of different things, but this is what I threw together and has worked well for me for over two years.
How can I tell if this will fit properly? Another fantastic question! - If you are concerned about this print, or any print, fitting properly...I would recommend printing test
******UPDATE******
Addressing some questions from a fan:
What height coffee cup will fit with this riser? Great question! - A 4.25" (108mm) tall cup should fit just fine.
Are the tolerances of this model exceedingly tight? Another great question! - Since tolerances are typically called out on a 2D print and are not part of the 3D model I can't really say. Any variability would be determined by the accuracy of your 3D printer.
Couldn't you have mimicked the original design? Dynamite! - I could have done a lot of different things, but this is what I threw together and has worked well for me for over two years.
How can I tell if this will fit properly? Another fantastic question! - If you are concerned about this print, or any print, fitting properly...I would recommend printing test
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
