Key Organizer

Designed to hold 3 keys with one key being your primary key. Outside of the printed parts you will need M3 screws and nuts (two of each). The screws length will depend on the thickness of your key organizer. I used 3M x 12 mm screws.

There are two halves of the outer body. The half with the spacer built in is for the primary key side of the key organizer.

The keycaps are made for your primary key. They are in two sizes for varying key heads. I recommend to print both and see which one fits your primary key.

The spacers are made to go between your secondary keys. They are in two different thicknesses to make sure the width of the key organizer is uniform from the primary key side to the secondary key side.