MakerWorld
Other House Models
Go to Model
Key Repair
92
Downloads
50
Likes
24
Makes
A friend asked me to repair his key, where the plastic had snapped off. I created this model in fusion 360 and printed on my A1. By adding a pause in the slicer your can insert the key and make it one part. Key was 9.2mm wide and had a thickness of 1.7mm. It also featured a rectangular locating tab which can be seen on the sketch in the pictures.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
