Key Wrap 2.0 - Six Variants

KEY WRAP 2.0    Wanted to update my key holder and made this one with a hinge (mainly because I wanted to have a go at making a print in place hinge).   This key wrap can hold up to 3 keys, folds open for easy changing of keys and has a built in keyring holder. (Requires an M5 x 20mm Nut and Bolt.) I would recommend using a Nylon nut to stop the loosening of the bolt when moving keys. I have included some 2D printable washers just in case you need them.   A short 40 minute print using only 17g of filament, prints in place. Does not require supports, prints well without them. I have used a brim in the print profile as I had a few failed prints without.   There are six variants including a valentine one.