Thingiverse
Keyboard Key Adapter
von DrewPy42
3
Downloads
2
Likes
0
Makes
A simple adapter to connect a key to a switch. The switch had a plus connection and the key had two slots. This small connector takes ~2 minutes to print. The model was built using TinkerCAD with the grid snap set to 0.1 mm. You'll need a printer with a small nozzle. I printed it on a LulzBot.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!