Thingiverse
Keyboard Keyer case "Barney"
door w8bh
3
Downloads
3
Likes
0
Makes
This is a two-piece friction fit enclosure for my keyboard keyer project. No screws are required.
Supports are recommended for printing the top half of the enclosure.
This case assumes that the Seeeduino XAIO has been directly mounted to the PCB using the castellated pads.
For more information on the keyboard keyer project, see http://w8bh.net/KeyboardKeyer.pdf
Supports are recommended for printing the top half of the enclosure.
This case assumes that the Seeeduino XAIO has been directly mounted to the PCB using the castellated pads.
For more information on the keyboard keyer project, see http://w8bh.net/KeyboardKeyer.pdf
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!