Thingiverse
Keyboard Wallet Case for Pixel 9
von a8ksh4
8
Downloads
19
Likes
0
Makes
There's not much to say about this except that it has a slide out keyboard and a spot for ID and credit card. Let me know if you have any ideas or feedback to improve this design.
I originally made the phone clip one piece, but it was too rigid to safely insert and remove the phone, so I split it into two parts that lock in the phone.
The keyboard works well for me so far. I did see that one of the two will not pair with my phone, maybe because they have the same BT name. Double check that your keyboard pairs and works with the phone before assembly.
There's one corner screw on the right phone clip that lets the slide rails widen up. You can pull this screw to pop out the keyboard and add a few layers of tape to the rail if you need to tighten things up a bit. Then put the screw back in and reassemble.
**Updates**:
* Rev 12 Phone Clip R has a retention clip added to help keep credit cards in place.
You're welcome to use & modify the design (but not sell):
I originally made the phone clip one piece, but it was too rigid to safely insert and remove the phone, so I split it into two parts that lock in the phone.
The keyboard works well for me so far. I did see that one of the two will not pair with my phone, maybe because they have the same BT name. Double check that your keyboard pairs and works with the phone before assembly.
There's one corner screw on the right phone clip that lets the slide rails widen up. You can pull this screw to pop out the keyboard and add a few layers of tape to the rail if you need to tighten things up a bit. Then put the screw back in and reassemble.
**Updates**:
* Rev 12 Phone Clip R has a retention clip added to help keep credit cards in place.
You're welcome to use & modify the design (but not sell):
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
