KeyChain Screwdriver Pocket Tool

This is a Keychain Screwdriver Pocket Tool that uses a common pen style screwdriver that I have found at Autozone for $1.50 and I'm pretty sure I've seen it at Microcenter, Home Depot and Lowes from time to time for about $2.

This little tool puts the following on your keychain:
1. A phillips head screwdriver
2. A flat head screwdriver
3. A magnet for pulling screws out of tight spaces. (the magnet also holds the bit in place).

What you'll need:
1. one map magnet 4mm x 10mm - these are available on amazon and at hobby shops.
2. one pen screwdriver tool (comes with two two-headed bits). The bits should measure just under 5mm. The bits that I used measured 4.95 to 4.96mm
3. Glue - I suggest a tiny dab of gorilla glue on the magnet before pressing the magnet in place. Don't use too much - remember it expands.

Printing Instructions:
1. Print both STL parts: PocketScrewdriver07.STL and PocketScrewdriverCap08.STL I suggest using a brim with 5 outlines to help keep the p