Keychain Trammel

Hello!

This is a keychain sized 2 way Archimedes trammel. It measures 36-36-8 mm (the handle sticks out a bit more) PLA was used for this model.

Recommended print settings:

.1 mm layer height
2 walls
Around 40-50 mm/s print speed
Supports for overhangs in the base only
Around 10% infill is recommended for all parts
Rotate the sliders so the holes are pointed up before printing
Raft was used (no heated bed)

Assembly:

Slight sanding/lubrication may be required for the sliders to slide smoothly
I used super glue to join the pins to the sliders. Make sure the handle does not get glued down as well.
Attach any type of keychain linkage.