Thingiverse
Keychron Q1 Basic Knob
by Kidharu
0
Downloads
1
Likes
0
Makes
Basic functional knob for the Keychron Q1.
Slides on nice and snug but also loose enough to not worry about removal.
Intent of this was just to get a base that fit clean.
Print at .28mm for a nice locking fit. Lower for looser. Thicker for tighter. Etc etc.
No support needed. Print upside down.
Will add photos and stuff to this later. Just wanted to put it online before I accidentally overwrite the file or something lol
Slides on nice and snug but also loose enough to not worry about removal.
Intent of this was just to get a base that fit clean.
Print at .28mm for a nice locking fit. Lower for looser. Thicker for tighter. Etc etc.
No support needed. Print upside down.
Will add photos and stuff to this later. Just wanted to put it online before I accidentally overwrite the file or something lol
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!