Keyforge Key Token - Multipart V3

# Update
I have added 2 new versions of the unforged side with holes in the bottom side so that you can insert weights. `Keyforge-key-revised_unforged-quarter-space.stl` has space for a U.S. quarter sized coin or weight and `Keyforge-key-revised_unforged-poker-chip-space.stl` has space for a standard sized poker chip but in order to accommodate that it is 2mm thicker than the normal one. I have not tried either of these but adding a weight was suggested and I thought it was a good idea. I see no reason why they would not work but you will need to print those with supports.



This remix makes the forged side all one piece and shaves a bit off off of the aember to make it sit just a hair below the top of the key. This revision is aimed at people that are looking to paint them, the seperate inserts in the origional V2 did not work as well for that and were difficult to get a good print of. Also, dropping the aember down a bit makes it so that after you paint them and glue them in pl