Thingiverse
KEYMOD_STUBBY GRIP by Logan
von whiteguy208
69
Downloads
46
Likes
1
Makes
Short keymod grip, only 2.3" or 60mm tall. Perfect for something to mash your hand into if you are a thumb over bore/ thumb forward shooter to really pull the firearm into your shoulder. This grip is intended to bolt directly into the keymod slots and skip the pic rail completely. I did this because I couldn't seem to find an acceptable forgrip that can be 3d printed and still be strong.
-Print vertically with support for best results.
-100% infill
-I recommend using nylon, but abs or petg would probably be fine. Pla will get too soft and the keymod screws will pull through the body of the grip.With nylon and the right settings this grip will literally support your body weight if you care to use your ar as a step ladder.
-Print vertically with support for best results.
-100% infill
-I recommend using nylon, but abs or petg would probably be fine. Pla will get too soft and the keymod screws will pull through the body of the grip.With nylon and the right settings this grip will literally support your body weight if you care to use your ar as a step ladder.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
