Keystone Mounting Port
von jcoehoorn
16
Downloads
8
Likes
0
Makes
Remixed from [Mounting plate for keystone jack](https://www.thingiverse.com/thing:6647). Most of the credit goes there.
I removed some material from the original to get a **much** better fit for my cat6 jacks, and slimmed down the border material to 1.6 mm.
For reference, the jacks I tested against are [CableCreation CL0080](https://www.amazon.com/CableCreation-10-Pack-Keystone-Module-Connector/dp/B01FHC1HXO).
Like the original, this part is intended for use in making other models. It's useful to print by itself to test your fit with the least amount of plastic, but otherwise it's only helpful when used as part of making another model.
I removed some material from the original to get a **much** better fit for my cat6 jacks, and slimmed down the border material to 1.6 mm.
For reference, the jacks I tested against are [CableCreation CL0080](https://www.amazon.com/CableCreation-10-Pack-Keystone-Module-Connector/dp/B01FHC1HXO).
Like the original, this part is intended for use in making other models. It's useful to print by itself to test your fit with the least amount of plastic, but otherwise it's only helpful when used as part of making another model.
jcoehoorn veröffentlicht auch auf
3 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
