Kiisu v4b Flip Case

__**It's a flip case for the Kiisu v4b!**__

All the cases I found were covering most of the electronics in some way or another. None of them really covered the screen. To give it more protection, and also keep all the sensors and buttons open (as I kinda prefer the unobstructed buttons), I made this here flip case! It's based on the slim case by ubermood, which you can find in the remix section. The battery and sd card are closed off, as I don't remove them often enough. I can upload a version with those exposed too, should anyone want that.

__When printing:__ I had no success printing both halves at the same time, as that would lead to bad warping on my Anycubic Kobra 2 Pro. I had no issue printing them separately,.

__Assembly:__ Depending on how good your printer is, it might be worth sanding the hinge part a little. The hinge is held together with normal 1.75mm filament.
**BE CAREFUL** when you place the Kiisu inside the case! It is a tight fit to prevent it from falling out.