MakerWorld
Robotics
Go to Model
Kinect sensor mount - locking mount with clamps for arca and pole mounts.
38
Downloads
12
Likes
19
Makes
This is a mount for a kinect sensor. Unlike many of the others on thingiverse this one is designed to be a very secure mount, while at the same time allowing the sensor to be easily removed.It uses sliding lugs to securely latch the kinect sensor to the mount. These mounts are tightened and held in place with 20mm M3 bolts and embedded nuts.The mount attaches to either an Arca style tripod mount, or the 19 or 25.4mm pole mounts with a 1/4" bolt (as used in camera equipment).The pole mounts use M5 bolts with embedded nuts.The sensor mount also has two grooves under it, 10mm offset from the mount centre, designed to fit 30.0 x 2.0 x 1.2mm ridges as seen on the arca or pole clamps. They are there to prevent the clamp twisting on the mount. If you wish to design your own clamps, you may want to include these ridges to prevent loosening/twisting.Print SettingsPrinter Brand:WanhaoPrinter: Wanhao Duplicator i3 PlusRafts:Doesn't MatterSupports: YesResolution:0.2Infill: yes. IIRC around 40%Note
Martin_au also publishes on
327 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!