Thingiverse
KiNG Uni Shroud
by Maikumizu
17
Downloads
13
Likes
0
Makes
My all in one replacement for just about any printer that uses a MK8 style hotend (14.3mm between the middle of the screws) Requires screws that are 4mm longer than you're using currently and I recommend using washers.
If you're using specifically the Sunlu S8 hotend (red/silver, doesn't matter) print the Stock S8 duct and ABL spacer. Also, use your short screw on the bottom for the stock 4010 and the long one on the top, I'll make this easier to thread at some point as it's quite a lot of meat to screw into currently.
If you're using a MK8 (CR10/ender, Aquila, Microswiss, etc) then print the MK8/Microswiss parts.If you're using a stock (for most machines) 4010, print the 4010 duct with the corresponding hotend you're using. Same goes for 4020, 5015. Pick your hotend, pick your fan, print ABL if needed.
ABL Offsets are: x30,y0,z-2
If you find my parts helpful, please consider donating to continue my research and progress in my projects.
Paypal: [email protected]
If you're using specifically the Sunlu S8 hotend (red/silver, doesn't matter) print the Stock S8 duct and ABL spacer. Also, use your short screw on the bottom for the stock 4010 and the long one on the top, I'll make this easier to thread at some point as it's quite a lot of meat to screw into currently.
If you're using a MK8 (CR10/ender, Aquila, Microswiss, etc) then print the MK8/Microswiss parts.If you're using a stock (for most machines) 4010, print the 4010 duct with the corresponding hotend you're using. Same goes for 4020, 5015. Pick your hotend, pick your fan, print ABL if needed.
ABL Offsets are: x30,y0,z-2
If you find my parts helpful, please consider donating to continue my research and progress in my projects.
Paypal: [email protected]
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
