Kingroon KP3s bed cable support

I printed the only one i found on here and i didn't like it at all so I designed my own

I wanted one that could be used if you didn't have m3 bolts and nuts on hand.

this will slide over the frame base and no hardware is needed all you need is a cable tie, but you can add hardware for piece of mind. (i have added hardware) i did a few prints and with friction fit it didn't move at all.

I found that my wires didn't come straight out from the bed they where slightly to the right side, i have made 2 versions one with a straight cable support and one that is 5 mm more to the right had side, check your cables to see which one will work best for you.

print with groove facing down on build plate, i suggest a brim/raft. no supports are needed !

i have printed in pla and seems to be fine. if in a enclosure id suggest petg.

not sure if will fit kp3 as i have kp3s if someone does print for kp3 let me know if it fits.

enjoy.