Thingiverse
Kingroon KPS3 Spool Mount
by rwmech
0
Downloads
2
Likes
0
Makes
This spool mount comes in two versions. Single piece (you'll need to print on another printer) or multiple pieces that prints on a KPS3 and you'll need to screw it together. M3 screws are used for assembly (I also recommend some glue). M5 and T-Nuts are used to attached to the top of the KPS3.
This spool holder aims to put the weight of the spool directly down so it does not cause vibrations when printing. I've been using this since I got the printer and works very well.
PRINTING:
If printing the AIO mount print the top against the build plate. No Supports are necessary.
Was this model helpful for you? Consider supporting my work in any of the following ways! Even the free options help the channel!
Consider dropping a tip https://koji.to/k/8E9J or consider supporting my ongoing work https://www.patreon.com/makersmashup
Purchase anything on amazon after visiting our store page https://amzn.to/429HusI. Just click this link first!
No cost option to support
This spool holder aims to put the weight of the spool directly down so it does not cause vibrations when printing. I've been using this since I got the printer and works very well.
PRINTING:
If printing the AIO mount print the top against the build plate. No Supports are necessary.
Was this model helpful for you? Consider supporting my work in any of the following ways! Even the free options help the channel!
Consider dropping a tip https://koji.to/k/8E9J or consider supporting my ongoing work https://www.patreon.com/makersmashup
Purchase anything on amazon after visiting our store page https://amzn.to/429HusI. Just click this link first!
No cost option to support
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
