Kitchen Door Clip

I have a pretty small kitchen and after a renovation, we lost the spot where we used to hang our dish towels. After some family brainstorming, we came to the conclusion that we need a whole new house... lol. But in the meantime (which could take a few years), the best solution was to design these clips to attach the towels to the door handles. It works pretty well and it went from a temporary solution to a permanent one.

Just a heads up: these clips were designed to fit the doors and handles I have at home. To make it work in your house, you may need to make some adjustments in X, Y, and Z so the clip fits properly in your kitchen.

Oh, and I'd like to point out:
- it's a quick print that doesn't use much filament.
- I've been using them in my kitchen for about a year now and haven't had to replace them yet.

Print Settings:
Material: PLA
Layer Height: 0.2
Infill: 15%
Walls: 3
Supports: No
Change filament during print: If you wish
Pause during print: No
Brim: No
Raf